• News
  http://www.gnostice.com/news.xml
• Articles
  http://www.gnostice.com/articles.xml
• Blog
  http://www.gnostice.com/blog.xml

Home | Online Demos | Downloads | Buy Now | Support | About Us | News | Working Together | Contact Us

Resetter Printer Canon G2010 [better] [ 2024-2026 ]

The software cannot communicate with the printer firmware.

The LCD screen should now return to its usual standby screen showing the number "1", and the blinking error lights will be gone. Your Canon G2010 is now ready to print again. Crucial Maintenance Warning: Clean the Physical Pads!

Which your computer uses (Windows 10, 11, etc.)?

If you need help finding the or are experiencing a specific error code during the process, please share the details below so we can troubleshoot it together! Share public link resetter printer canon g2010

In the "Print" section at the top, click EEPROM . The printer will feed a sheet of paper and print a line of configuration data. Look for D=000.0 , which proves the waste ink percentage is now officially zero. Completing the Reset Process

After the Service Tool confirms the execution, you must power-cycle the printer to save the settings to its internal EEPROM chip. Close the Canon Service Tool software on your PC.

The printer must be placed into a special diagnostic mode. Turn off the printer. Then, while holding down the Stop/Reset button (the triangle inside a circle), press and hold the Power button. Keep holding the Power button, but release the Stop/Reset button. While still holding Power, press the Stop/Reset button twice (or five times, depending on the firmware—two times is standard). Then, release the Power button. The green power light will flash, then remain steady. The printer is now in Service Mode. The software cannot communicate with the printer firmware

Once the counter hits 100%, the printer locks up to prevent ink from overflowing and damaging your desk or the printer's internal circuit boards.

while still holding the Power button down.

Before attempting a reset, it helps to understand why your Canon G2010 stopped working. Crucial Maintenance Warning: Clean the Physical Pads

Press and hold down the Stop button (the triangle inside a circle icon).

Install an (dump tank). This routes the printer's waste ink tube outside the machine into a small plastic bottle, ensuring your internal pads stay dry forever.

Before you can use the resetter software, you must put your printer into a special state called Service Mode. The software cannot talk to your printer without this step.