A frequent point of confusion is the for the ultrasound software. This is often mistakenly called the "bios password."
Disconnect the ultrasound from AC power, open the BEP chassis, and remove the coin-cell CR2032 battery from the motherboard for roughly 5 minutes.
For the HP Vivid E9:
If the system is under warranty or a service contract, the safest route is to contact GE Service. They can provide the exact password based on your system’s serial number and software version, ensuring you do not void your contract or risk damaging the sensitive ultrasound front-end electronics. Vivid E9 Bios Password
Changing underlying BIOS settings (such as overclocking or altering power states) moves the device out of its FDA-validated state, which can create significant legal liability for a healthcare facility if a patient injury occurs.
Restart the Vivid E9. Immediately press the Delete key, F2 , or F10 repeatedly (watch for the "Press __ to enter Setup" prompt—usually F2 on Intel motherboards). When the blue BIOS screen appears, enter the password.
: If the system is protected, a password prompt will appear. Input one of the passwords listed above. Service and Administrative Credentials A frequent point of confusion is the for
Managing how the motherboard communicates with vital internal components like the beamformer boards, backend processor, and proprietary video capture cards. Common Scenarios Requiring BIOS Access
GE uses standardized BIOS passwords across specific motherboard generations of the Vivid E9 system (such as the BT11, BT12, or subsequent hardware revisions).
If technical support is not immediately available, you can try resetting the BIOS settings to factory defaults. the Vivid E9. Unplug the system from the AC outlet. They can provide the exact password based on
: Select External Service from the drop-down menu.
Move the plastic jumper cap from pins 1-2 (default position) to pins 2-3 (clear position). Turn the system on for 10 seconds, then power it back down.
Reassemble the unit and power it on. Note that resetting the CMOS will clear the custom GE boot configurations, meaning you will need to re-enter the correct factory-specified BIOS parameters for the ultrasound software to boot properly. Important Regulatory and Service Warnings
Changing the boot sequence to run hardware diagnostics from a USB drive or external DVD-ROM.
What are you trying to configure or replace?