V2ray Mikrotik !exclusive! [Updated × 2025]

Create environment variables to pass your V2Ray config details. This is an alternative to mounting a config file, making it easier to manage on RouterOS.

/ip firewall filter add chain=forward action=accept in-interface=dockers out-interface-list=WAN /ip firewall filter add chain=forward action=accept in-interface-list=WAN out-interface=dockers

Which (VMess, VLESS, Trojan) or encryption type does your server use?

Create a virtual ethernet interface for the container: interface veth add name=veth-v2ray address=172.16.10.2/24 gateway=172.16.10.1 v2ray mikrotik

Create a bridge for the containers and a virtual ethernet interface to act as the "bridge" between MikroTik and the V2Ray container.

To allow the container to access the internet to connect to your V2Ray server, you must set up Source NAT.

The process is the same, but with a different Docker image, such as alireza7/x-ui (which provides a GUI to manage server configurations). You will also need to perform on your main WAN interface: Create environment variables to pass your V2Ray config

/ip/route/add dst-address=0.0.0.0/0 gateway=172.17.0.2 routing-table=v2ray-table Use code with caution. Phase 4: Verification and Maintenance

/ip route add disabled=no distance=1 dst-address=0.0.0.0/0 gateway=172.17.0.2 routing-table=proxy_mark

/container add remote-image=teddysun/v2ray:latest interface=veth1 root-dir=disk1/v2ray \ mounts=config:/etc/v2ray start-on-boot=yes Create a virtual ethernet interface for the container:

Use a trusted, lightweight V2Ray image from Docker Hub (such as v2fly/v2fly-core ).

Create a virtual network interface to connect the container to your MikroTik bridge.