Turn on the scope. Press System , then select Upgrade (F2). Connect to PC: Use the USB cable to connect the to your computer. Select USB Mode: In the system menu, select USB as " MSC ".
Updating the OWON HDS2102S Go to product viewer dialog for this item. owon hds2102s firmware update
OWON HDS200 series oscilloscopes typically utilize a straightforward USB mass storage upgrade method. Turn on the scope
| Version | Notes | |-----------|-----------------------------------------------------------------------| | 1.0.1 | Early production | | 1.1.2 | Improved FFT stability, fixed trigger holdoff issue | | 1.2.0 | Added waveform recording/playback, better LAN stability (if equipped) | Select USB Mode: In the system menu, select USB as " MSC "
Connect the USB Type-C cable to the oscilloscope and your PC.
, first check community forums to see if others have the same issue and if a solution exists. Then, contact OWON support directly. Provide them with your device's exact hardware version (found in the About menu) and current firmware version. Ask them explicitly if there is a firmware update for your specific device that addresses the issue you are facing and request the update file and procedure from them directly. Do not use a file from the website without their confirmation.
Disconnect all probes from the inputs, press , select Calibrate , and let the routine run for a few minutes until it completes. Troubleshooting Common Update Failures