According to official guidelines, proper installation is critical for system integrity:

Utilize the push-to-connect terminals to connect the lubricator unit to the central controller. Safety Guidelines

You must define the "On" and "Off" times. Precision is measured in milliseconds, allowing for "shot-to-point" lubrication that hits specific chain pins without dripping.

Press and hold the Manual Run / Prime button on the face of the controller. The pump will run continuously.

Before opening the enclosure, . Refer to the internal schematic label on the enclosure door for exact terminal numbering. Standard configurations include: Power Input: Terminals L1, N, and GND.

Route high-voltage motor cables away from low-voltage sensor lines; confirm solid earth ground.