: The latest .bin file specific to the WS-6906 model.
Set to 115200 (standard for this device). Operate Mode: Select Upgrade . Step 4: Load the Firmware File
: Download and extract the update utility and the .bin firmware file to your computer.
Updated software often brings improved algorithms, allowing for quicker signal identification and dish alignment. Satlink Ws 6906 Software Update
The meter will automatically reboot. You can now safely unplug the cable. Troubleshooting Common Update Issues
If you encounter issues during the update, try the following solutions:
Ensure the finder battery is charged above 50% or plug in the wall adapter. Step-by-Step Update Process 1. Download the Required Software : The latest
Click the or Open button within the tool, navigate to your desktop folder, and select the downloaded .bin firmware file.
: Connect the Satlink finder to your PC using an RS-232 cable.
Click or Next in the PC program. Immediately turn on the power switch of your Satlink WS-6906. The software should display a progress bar showing data transmission. 6. Complete the Process Step 4: Load the Firmware File : Download
Connect the other end of the cable to the COM port on your computer. Step 2: Launch the Updater Tool Open the application on your computer.
Once the download hits 100%, the software will flash the EEPROM memory. Wait for the "Upgrade Success" pop-up window to appear. Troubleshooting Common Errors Target Not Connect / No Response
Launch the Satlink upgrade software on your PC. Configure the following settings within the tool: Select the matching COM Port number found in Step 1.
You must find the correct .bin file. It is recommended to check specialized satellite forums or contact the manufacturer. Download the ( .exe file) as well Satlink WS-6906 Software Upgrade Guide . 2. Connect the Device to the PC Connect the RS-232 cable to your PC's USB port.
Plug the 3.5mm jack end of the cable into the on the Satlink WS-6906. Keep the Satlink unit turned OFF initially. 2. Preparing the Software on PC