The system's operation can vary slightly depending on how it was originally configured. Use this table as a quick reference guide for the most common functions. You can refer to the comments on the BMW Motorcycle Club forum for these basic press patterns.
The TXSHS is a low-power transmitter that sends a remote signal at to control your vehicle's security. This is the same frequency many modern garage door openers use, so interference is rare.
Press once. The indicators flash twice and the alarm may beep twice. Disarming (Button 2): Press once. The indicators flash once. Panic Alarm:
If you need to lock the vehicle but leave it in a situation where it might move (e.g., on a ferry), press the Left Button twice . The indicators will flash three times, accompanied by three beeps, indicating the motion sensor is bypassed. Disarming/Turning Off the Alarm Gemel Txshs User Manual
If “Gemel” is a brand and “Txshs” is a model:
The Gemel Txshs is engineered for longevity. Follow these monthly checks:
You can find detailed step-by-step instructions for this system in the BMW DWA 6 Instructions for Use. The system's operation can vary slightly depending on
Failure to follow these safety instructions may result in injury or equipment damage.
If you need to dig deeper into your system's setup, tell me:
If you need help tracking down a replacement casing or checking system compatibility, let me know the , the current color of your key fob casing , and whether your system features an active siren box . Share public link The TXSHS is a low-power transmitter that sends
The motorcycle's turn signals/indicators will flash twice . Depending on your specific regional module configuration, this may happen silently or with a brief chirp. The immobilizer is now active, and the tilt/motion sensors will trigger the siren if the bike is moved. 2. Disarming the Security System Action: Press the Right Button on your remote key fob once.
Test the remote near the vehicle. If it doesn't work immediately, you may need to press the button 5–10 times rapidly to re-synchronize it with the rolling code receiver. 5. Programming New Remotes
Subscribe now to keep reading and get access to the full archive.